RUNRMTCMD getiing Invalid User ID message

[Diane Mueller]

[Diane Mueller]

I use RUNRMTCMD quite a lot. Try this and get back with me if it doesn't work. At a DOS prompt type: C:>cwbrxdop save /usewinlogon You will see a long msg--bottom line of which reads--CWBAR1034--Windows logon security will be used if *NONE is specified, currently configured options are: /usewinlogon Then on the RUNRMTCMD specify *NONE for userid & Password. The user profile and password used to sign on to the PC will be used to access the AS/400. Be sure that the user ID & password used to logon to the PC are also valid userid & password on the AS/400. User must keep PC logon and AS/400 logon in synch. And of course if the PC user logs on as administrator, this will not log him on the AS/400--It is too long for a 400 userid. JoAnn infosys2@amm.org
________
Painful Double Penetratio

[rkc@entrack.com]

I am trying to execute the RUNRMTCMD but am getting an error message that the Required User ID is missing or Invalid. CWBAR1010 CWBAR1018. We are using client access express. I have gone into Client Access Remote Command tab and changed system and user to be * for both. I tried it again but still got the same error message. I also tried putting in a remote user ID and password in the RUNRMTCMD but that didn't work either. Can anyone tell me what to look for next? Thanks. Ron

[rkc@entrack.com]

Joann You were correct. The user PC logon and AS/400 logon were not in synch. Thanks.