Error When Using A Printer with TFRM36

[Guest.Visitor]

When I use STRPASTHR to attach to our M36, I can use printer P6. When I use TFRM36, I can use the printer except for one procedure. When using TFRM36 on this particular Proc I get the message: "SYS0458 Error opening output queue" What gives? Any ideas as to why I get this error only on this one procedure, and only when I use TFRM36? The same procedure works fine when attaching via STRPASTHR. I'm at a loss after spending several hours trying to resolve this. TIA Wes

[Guest.Visitor]

I'd start by looking at the printer definition on the AS/400 side, the WRKCFGM36 and SSP configuration. It sounds like you might have the printer defined the same. Or the particular program has a printer "coded" in the OCL.