Try using the SENDPA FTP command after logging in. This will change your FTP session to an active one. <p>BRyan

Bryan - <p>That did the trick. Thanks for the advice. <p>Mark

I am having a problem with an AS400 to AS400 ftp transfer over the internet. I connect and log on OK, change to ascii, change namefmt 1, then attempt a "put" and that is where it hangs. When I run wrkactjob it shows my ftp job in a TIMW state and it stays there indefinitely until I manually end the job. See below for the script commands and log output. <BR>
Any suggestions? <p><!--mccodelink_begin--> <BR>
<!-- do not remove --> <BR>
<hr width=50 align=left><small><a href='http://www.mcpressonline.com/mc/showcode@@.6ae8ba19' target='_blank'>Code</a></small> <BR>
<!--mccodelink_end-->